EII – Wet Mix Dust Collector

PART # SYS-050-18300300

  • Wet mix dust collector, fabricated from 14 gauge stainless steel which is then thermoset powder coat painted.
  • Automatic low water shut down sensor which prevents the unit from operating if water is not set at proper levels.
  • Site glass to visually check the water level.
  • Manual water level system whereby the customer fills the unit with more water when the water level reaches mark on the site glass.
  • Manual drain valve located at the bottom of the separator.
  • Initial stainless steel venturi entry for deep penetration into the water, secondary baffles to completely mix the dust particulate with the water whereby no after dry/hepa filter is required.
  • A time delay switch is provided to prevent the start of the dust-producing process (sanding tools) until the collector is in complete operation.
  • An off delay time switch is provided which allows the system to run for a set amount of time once the sanding has stopped. This ensures all dust in the hose reaches the collector.
  • System includes (2) 25’ lightweight anti-static hose with attached airline

*Patent Pending

Join our mailing list »

Specializing in Automotive, Industrial, and Wood Refinishing Equipment &
Commercial and Industrial Make Up Air Equipment Sales, Service and Installation

Serving the Ohio and Pennsylvania markets

13837 Hawke Road   |   PO Box 789   |   Columbia Station, Ohio   |   Phone: 440-236-6192   |   Fax: 440-236-6819

All Rights Reserved 2018, Cleveland Spray Booths Specialists - Admin Login   |   Digital Marketing by Alt Media Studios